Need pump mag info

[dockman]

I was lucky enough to get mt hands on a pump kit for my mag but I need a little info so I can get it put together. Dose anyone have detailed diagram or specs for where the main body needs to be milled for the pump kit to work? Or if someone knows a shop I could send it to that can mill it for me?

Any information would be appreciated.

[cougar20th]

email me at cougar20th at hotmail. and ill email you back the info your looking for.

[dockman]

email me at [email protected] and ill email you back the info your looking for.

Email sent, thanks.

[cougar20th]

Email sent, thanks.

replied. congrats on getting the pump parts. they are fun to use

[hs2000]

email me at cougar20th at hotmail. and ill email you back the info your looking for.

Could I get some of that info? I am assuming your selling the millings? email me, [email protected]

[phizz]

check this out http://airsoldier.com/~haveblue/tech/automag/index.html not sure if it will help or not.

[hs2000]

check this out http://airsoldier.com/~haveblue/tech/automag/index.html not sure if it will help or not.

I have looked a that a half dozen times now, but it doesn't tell me the dimensions that the body needs to be milled.

[RRfireblade]

I have looked a that a half dozen times now, but it doesn't tell me the dimensions that the body needs to be milled.

The body just needs to be relieved enough to clear the pump arm. It's not a critical DIM.

[cougar20th]

the info that is on airsolder is what i had sent to dockman. i then sent it to haveblue who put it on airsolder.

[doc_Zox]

this should help:

[hs2000]

wow, thanks a lot. That's a big help. Judging by the picture the 5 mm slot isn't very deep, but it seems to get deeper as you move towards the opening, that's not how it has to be right? What's the reasoning why you did it that way?
Thanks again, it's really helpful.

[doc_Zox]

i bought a used mag on here and thats the body that was on it

i'm pretty sure from the look of the milling, that that is an AGD factory pump body

the ramped slot looks like typical Tom Kaye attention to detail

[doc_Zox]

http://cgi.ebay.com/AUTOMAG-PUMP-BOD...QQcmdZViewItem

$57.50 and one can be yours

[hs2000]

^no way, I got to have center feed.

[mpsd]

this should help:

Do you have this for the pump rod as well?

Thanks!