Quick Question

[theedge634]

If i wanted to replace the 68 mag rail with a RT Pro rail, do i need to change anything, the other gear i have is a hyperframe, X-valve lvl 10, and ule body.

Will the ULE trigger kit work with a lvl 10

And one more thing whats the operating pressure of the x valve,

[FinchMan]

you also need to replace the classic sear& searpin with a rt-pro sear and searpin.


the ult will work fine with the lvl10 in an xvalve, just make sure you have one tuned before you add the other, that way you're not trying to tune/troubleshoot two things at once.

the xvalve can theoretically take pressure up to 3000 psi, but it regulates it down to around 300-400 psi internally. Just use a normal (not Low Pressure) HPA tank, and you'll be fine.

[theedge634]

you also need to replace the classic sear& searpin with a rt-pro sear and searpin.


the ult will work fine with the lvl10 in an xvalve, just make sure you have one tuned before you add the other, that way you're not trying to tune/troubleshoot two things at once.

the xvalve can theoretically take pressure up to 3000 psi, but it regulates it down to around 300-400 psi internally. Just use a normal (not Low Pressure) HPA tank, and you'll be fine.

One more thing am i going to have compatibility problems with teh hyper frame and Lvl 10
Because someone on this forum earlier said i might,