my emag works fine except for when a ball semi feeds and the level 10 stops it from chopping. once the level 10 stops the ball break, it doesnt reset in either mechanical mode or emode to get ready to fire again. i have 2 on offs and im not sure if it does it with both. both are emag on offs though. any suggestions?
-
Last edited by Troen; 02-03-2006, 06:48 PM. -
maybe the carrier in the lvl 10 is to small and the friction keeps it from recocking ? gl i had this issue when my tank was low also u should use a 800 output tank btw that helps alot
gl on thin one
-
add a shim or 2 to the level 10. If it leaks down the barrel take one out.
Comment
-
i have it running at 900-950 psi and ill try the shim once i get airLast edited by Troen; 02-03-2006, 07:41 PM.Comment
Comment