I have an Xvalve Reverse that is leaking out the small bleed hole directly across from the air input on the front half of the valve. Level 10 works good. 1.5 insert, 2 shims and the small spring. It is a slow leak that stops when the trigger is held back. What O-ring or part could cause this leak. It is a new valve with less than one case of paint through it. Thanks in advance for the help. RB
-
Good Traders-Tobz,Blennidae,GhilleGuy,Snake847,jondon005,dzaide ,LuisV,CodeMA,Prezents,badinfo,B.C.,jeffremiller -
Lube or replace the reg pin orings. That hole is the high pressure bleed off so something is not right.
-
Lube-ed up some brand new o-rings, still leaking out the vent hole. Turned the pressure down, which brought the velocity down too, but it still leaks?Good Traders-Tobz,Blennidae,GhilleGuy,Snake847,jondon005,dzaide ,LuisV,CodeMA,Prezents,badinfo,B.C.,jeffremillerComment
Comment