PTP Micromag

[yellowpumpguy]

What kind of feed neck does the PTP Micromag use? This is the newer vertical feed model. The current, which appears to be the original feedneck does not fit any loaders I can find. It's far too large, I have to add copious amounts of tape the neck of the loader for it properly fit. I would much rather just have a feed neck that held the loader properly. From what I can tell it appears to be an STO Autococker style feed neck, but I'd rather someone who actually knows to tell me. That way I can be sure I'm spending my money on the right feed neck. Thanks.

[automikey]

I used a hacksaw to lightly carve two grooves about 1/4-1/2 inch apart around the neck of the hopper so they would hold 2 o-rings. Then you can take up the space without using tape.