Quick Sear Question Again

[ttink]

Hey, for the classic sear axels, how does the axel stay in the rail? is anything special needed to hold it in?

[Gunga]

There's a slot in the rail that the sear pin sits in.

[ttink]

There's a slot in the rail that the sear pin sits in.

Ya, I can see this, but does the pin ever bounce around or anything? or does it sit up against the body too?

[Tao]

The body pushes the pivot axel down into its slot in the rail. The is a hole for the part of the sear that catches the bolt and a hole where the sear pushes the on off pin and the body in the middle (over the sear axle).
I have my classic mag dissasembled so I just checked :)

There might me about a milimetre of bounce or so.

[ttink]

ok, thanks thats what i was looking for.