OK, got the LUKE work done, but after firing about 350 - 500 rounds through it, I turned it off. Now when I turn it back on the light on the T-board comes on, and then slowly dims until it is dark.
If I push the on/off switch to the left the light comes back on, then dims again. If I just hold the switch toward the on position, or hold it in, it stays on.
I thought my battery was dead, so I threw a Pro-cell 9 volt on there, and same problem
Any ideas?
Styg
If I push the on/off switch to the left the light comes back on, then dims again. If I just hold the switch toward the on position, or hold it in, it stays on.
I thought my battery was dead, so I threw a Pro-cell 9 volt on there, and same problem
Any ideas?
Styg
Comment