Odd Warp Feed issus....

[supercow]

I'm having a warpfeed issue that I've seen quite a bit here. Unfortunatly, the answers didn't seem to work for me so far. So I've had my warpfeed sysem on my mag for about a year now. I've had no prior issues. Saturday I'm playing indoor for the first time this winter (im poor this year) so I replaced all my batteries and tested everything. Everything worked. I left and realised I lef the batteries connected. As you all know, this means dead 9V batteries overnight. I tested the warp feed one last time by knocking on the side. Nothing. This is unusual I'm thinking. Well, I go to remove the battery and realise the battery lead has come unconnected from the board. I take it all apart and re solder it on. Workes again, but only for a second as the other lead is now off. I resolder that on. No its not working at all. My connections have all been tested and are fine. I noticed I was missing a spring in the little box. I found it and put it back in place. So final tally. The warp feed workes when you press the button to prime it. Knocking on it does nothing. So I'm wondering if this is the sensitivity disk (I've turned sensitivity and dwell everywhere with no luck) thats not working anymore? I have onejumper on dewll, and on the rightermost set of jumpers, I have a jumper one jumper at the bottom of the three(which I believe is the senser on position). PLEASE, I NEED YOUR ASSISTANCE.

[Aslan]

warpfeed

I have virtually no understanding of the jumpers...wish I could help you.

I bought a used one that the guy had said up for intellifeed. I wanted to convert it back to snesitivity to put it on a blowback but when I moved the jumpers like it told me to...it wouldn't work. It works with the intellifeed wire...but not in sensitivity mode. I think I'll be able to dremmel my triggerframe to accept the intellifeed...but it would have been easier if the sensitivity mode worked. Maybe it's the sensitivity disk you were talking about.

[blamtro]

It sounds like you missing 1 of the 2 or possibly both of the springs that connect the board to the sensitivity disk. Look at the diagram on airgun.com to see where the springs go.

[supercow]

Well, thing is, I have a plain old benchmark frame, there is nothing to hook the inteli-feed up to. Next, both springs are in, I checked them earlier. I know they both there. Perhaps its time to send havok an e-mail...

[AGDlover]

yea Havoc would be the man to send ur warp to