Emag On/Off Runaway problem

[Alpha]

Installed a new emag on/off in my X-valve.

Gas it up and fire under hybrid mode... Nothing...

Fire Electric mode... Nothing

Pull trigger in mech mode... One shot.. Felt crisp.

Try to make it bounce... I get insane runaway (at least 15+bps)

Kinda cool, but I cant make it stop. I slipped my finger into the breech to manually stop the bolt from cycling,and it starts venting (My LX is tuned nicely, otherwise I wouldnt have done that). It vents, and I figure if I let go, it will end the cycle.. But it picks up again.

Only way I can stop it is by hitting the safety.

Kinda cool.. But I want it semi, not OMGWTFBBQ mode.

[Tunaman]

Did you put the large oring down in the on/off hole before putting the on/off assy in there?

[Alpha]

Yes sir,

Its in there snug as an o-ring under a mag on/off.

EDIT:

I was actually thinking it MAY have something to do with my battery being low and the noid not having enough juice.. I dont see the logic in this, but as far fetched as it sounds, I'm about to try my new fully charged bat.

[Alpha]

Tuna,

I just popped in my old on/off (its a ULT with about 6 LX shims), and its working flawlessly (although it just started chuffing because I'm around that 1000PSI mark on my tank)

[sean33]

dude dont feel bad MY DAMN X-MAG IS STILL NOT FIRING IN ELECTRIC MODE...i dont no why...its really starting to make me mad...somthing is wrong i cant figure it out and i dont think its the ace its somthing not workin electricly...????

[Alpha]

I'm so sorry. I dont know how to tell you this, but your x-mag has herpees.

[sean33]

tunna i think i need to send my X-mag to you...maybe you can figure out whi its acting up?

[sean33]

no way dude...it was fine all along then its starting to take over and not listen to its master...Sam what do you think the problem is?? should i send it to Tunna??
lmk

[Alpha]

I'd have to take a look at it.. As you experienced the other night, when I'm at work the boss man doesn't like it when I work on people's markers... They want you to pay the gun techs (who are my managers) to do that.

[sean33]

ya dude i here ya..dude it stopped firing the last game i played and i went to the booth to tested it and it didnt work...ahhhhh i even cleaned my ace and went threw all that stuff...it just doesnt fire in electric..i put the ace on and it doent fire in mech mode when the ace is on...so i dont think the ace is the problem..

[sean33]

dude i wonder if this has happend to anyone else?

[sean33]

i think im gonna have tunna check it out.

[sean33]

i need 3.2 anyways

[sean33]

Sam, what was that site with the e-mag doing like 34 bps??