warp feed problem, hopper feedneck

[AJcool]

My new viewloader tripod loader wont stay in my warp feed body, it already fell onto the field while running off the break once, any ideas how to make it snug? its un-sanded and brand new

[Tao]

My new viewloader tripod loader wont stay in my warp feed body, it already fell onto the field while running off the break once, any ideas how to make it snug? its un-sanded and brand new

One thing you can do is loosten the warp housings screws around where you put the loader on a little bit. After that put the loader in then tighten the screws. If that doesn't work try doing the same things but put some rubber bands on very snugly onto the neck of the loader. You could try hockey tape too but you have to be sure it doesn't slipe up or slide down and block the feed hole for that matter.

[Wizzman]

YOu can also put some electric tape on the neck of the hopper to make it a lil more snug then put it on the warp feed while screwing in the the screws on the warpfeed to make it even more snug...

[shades]

I have one of these. It works great to mount my hopper to my Warp. You have then clamp the Warp on to the revy once you put this in the revy neck.

[AJcool]

how do you know what size to get

[shades]

how do you know what size to get

It has been awhile since I bought mine but I believe I have a large (largest) one. CP told me it was the internal dia that was different. Works for me.
]
Heres a pic of mine. link does not work for thumbnail.

[ThePixelGuru]

Heres a pic of mine. link does not work for thumbnail.

Now it does.