E-mag solenoid problems?

[Knightmare96]

I have an e-mag with 3.2 software running in it. The display will show trigger "on" "off" so I know the sensor is working fine with the magnets. But the gun wont fire. I have 800 psi going into it, and can manually fire it with mech mode, and by pushing down on the solonoid. But it will not fire. I have fully charged my battery. The leads from the solonoid apear to be in the correct spots. Is there a close up of the board, that I can compare mine to , to make sure the wires are in the right spot?

Also if anyone has any ideas, I would greatly appreciate it.

[shades]

I had THIS EXACT problem Last month.
It is your Battery.
I had One bad cell in the pack and my mag would not fire in Emode. Oh yes my friend, my battery seemed to charge just fine. When it was done charging it had >18volts. But still no go. SO... I slapped my sons batteryform his E mag on and pow pow pow. No problem. This is what I did. CLICK HERE (follow thread)or you can tear into your pack and find the offending cells and replace them.