No leak...no shoot

[PBCapo]

Basic Story:
My x valve with ult and level 10 worked fine with my am/mm rail. I switched to an rt rail, an rpg shado(in the process let the x valve sit alone for like 2 weeks). When I gas it up, sometimes it will leak down the barrel, then i shoot it and it cycles once and the leak stops, then there is pressure on the trigger from the pin, but when i pull the trigger nothing happens. Other times when I gas it up it skips the leaking part and goes right to the pressure on the pin but no shooting. I oiled the reg assembly, the level 10 carrier, and the on/off pin on the ult excessively. I switched the ult amount of shims from 0 to 6 and back to no avail. I switched the level 10 carriers from 4-0 and back to 3 where it started...no help. Is the problem with the sear, level 10 carrier, or is it something else that i'm not seeing? thanks!

[Chronobreak]

sounds like you forgot to get an RT sear

am/mm rail uses classic sears, rt pro rails use rt sears

[temilotzin]

Sounds like chronobreak is right try putting your valve back in the am/mm and see if it still works fine. If it does you know the problems with the rt pro assembly

[PBCapo]

lol how would i stick an am/mm sear in an rt rail? I have an rt sear and pin. I don't, however, still have my am/mm rail and sear, so I can't test it in that

[PBCapo]

i also have a spare red rogue rail with a different rt pin and sear, and the same thing happens when hooked up wtih that rail

[PBCapo]

no rogue i switched like 0-4 as in 0 1 2 3 4, i dont think the carrier is too big, sliding the bolt in my hand it sticks quite tightly, maybe the carrier o ring...i'll replace that

[PBCapo]

went down a carrier size, switched carrier o ring on original carrier, about to go up one, gonna switch all the shims on the ult again and then i'm sick fo this haha, i'll muster up the 50 bucks for tuna

[PBCapo]

AH IT WORKS! I put a ridiculous amount of shims in the ult, and it wouldn't fit in my ule body anymore lol. So i took one out and it fit...i believe I have 5 or 6 in there now, and it works! thanks for the help everyone!