cant stop bounce

[BOB THE ALMIGHTY]

Hey ive had my mag for a while and i love it. However now that im lookin to play some speedball i want to get rid of the bounce so i dont get discualified. Ive tried to reduce the pressure, and when i got to the point where it wouldnt bounce it would leak down the barrel alot. When that happened i tried adjusting shims to see if the leaking would stop. I replaced all of the o-rings and still had a little leak. I did this with three different spring lengths and still nothing works. I was wondering if the length of the on/of pin or sear could be the problem. I just want the bounce and the leak to go away. So any help to get rid of this problem would be very much appreciated.


setup:
X-valve
lvl ten-2 shims middle spring
green 14inch freak
inteli frame
88ci smartparts max flow-800psi-high reactivity

[JRingold]

I would suggest the ULE Trigger Kit. It pretty much eliminated the bounce in my X-Valve, well except when I put 1000psi into it. Then it doesn't bounce, but it is at the beginning stage of run-away and I get some double shots. Input pressure under 800 doesn't bounce for me and doesn't go into run-away either.

[BOB THE ALMIGHTY]

I would suggest the ULE Trigger Kit. It pretty much eliminated the bounce in my X-Valve, well except when I put 1000psi into it. Then it doesn't bounce, but it is at the beginning stage of run-away and I get some double shots. Input pressure under 800 doesn't bounce for me and doesn't go into run-away either.

ya i was thining of that but i was wondering if i could avoid that by doing somthing to the sear or to the pin. Since well at the moment im really short on cash. but that still doesnt acount for the small leak down the barrle unless the problem really is with the on/off pin

[FinchMan]

yup

your going to need the ULT. I'd probably just get it to be able to shoot faster anyways.

Either get the ULT, or maybe get/make a pneumag/spydermag/hypermag setup.

[BOB THE ALMIGHTY]

pneumag/spydermag/hypermag setup.

im not familiar with what those mean ...im guessing it requres valve tweekage but idk what ...any ideas"?

[Cow hunter]

im not familiar with what those mean ...im guessing it requres valve tweekage but idk what ...any ideas"?

no valva tewwkage required, they're new/modded trigger frames that only need bolting on the marker.
hypermag=electronic mag frame(no longer made)
spydermag=spyder frame(electro) modded to work on mags
pneumag=air assisted trigger(really fast, feel of an electro with no batteries)


/off topis; where in CT are you at?

[Tunaman]

I have pins that range from .660 to .770. Not EVERY mag will take the stock pin. We need to measure yours and go one a little longer.

[BOB THE ALMIGHTY]

I have pins that range from .660 to .770. Not EVERY mag will take the stock pin. We need to measure yours and go one a little longer.

so the longer the pin the less the reactivity...SHIBBY....in that case do you know where i can get a longer one ?.....



by the way cow hunter im just outside of enfield ....towards mass