Changing fire mode on Xmag/emag

[ABTOCMEPTb]

In manual it states that press upper button untill it shows fire mode than press lower button to change it.

But in both my xmag and emag there are no such mode on the screen.

All I get is: Total shots, ACE, SPS, SHBF and Trigger OFF.

I dont even have timer. So what do I do wrong.

P.S. When I removed clip with wire loop from the board nothing has changed.

[Dayspring]

You have 3.2. That manual was written for 2.4


ACE = Anti Chop Eye (0,1,2)
0 = off
1 = on
2 = half shell paint (may or may not have this)

SPS = Shots Per Second
limits ROF

SHBF = Shot Buffering
This is in milliseconds. It is the amount of time that the gun will wait before looking for another trigger pull. Lower is faster, but TOO low can introduce bounce or runaway.

Trigger Off = Trigger test mode
This will change from Trigger Off to Trigger On when the sensor picks up the magnet. useful for setting your trigger.

That wire loop is now used in the ACE board connection. If you only have an Emag, leave it in/take it out. Doesn't matter.

Timer function was removed in 3.2.

[ABTOCMEPTb]

Ok, thank you!

Now I got it. 3.2 is semi-auto only......

So what emag can do that tac-one ULE cant?

[Dayspring]

Nothing so long as the Tac One has emag electronics on it.

The difference between an RT Pro and a Tac One is the body & rail.