barrel problems with my mag

[mike19087]

alright so i was playing with my mag and all the sudden the bolt started stopping at the position where it hit the ball. so i was investigating this problem and then i try to take my barrel out and what do u know i cant take it out i twist it out of its normal position and try to take it out but it wont go to far in either direction it wont come out and it wont go back to its normal position. any help it would be hugely appreciated!!!!!!!!!!!!!!!!!!!!!!!!!!!
mike19087

[Walrus]

Have you dissasembled your gun (just the main parts, remove the body and valve from the rail) and tried to get the barrel out? Generally if there is nothing there to hold the barrel in then you should be able to get it out. I have had some trouble getting my barrels in or out and it is always because of the twistlockpin.

[>><<]

Ya mine does this to but just disassemble everything and just take the barrel which may or may not have the front of the bolt in there and bang it on the ground and it should come out no problems, but i really don't know why this happens.

[REDRT]

If you using a twist lock barrel and it sounds like you are. Just pull the valve and loosen the front screw of the grip frame. Possible problem is the twist lock pin set screw is too tight not allowing the pin to push in to remove the barrel. You should be able to adjust it when you pull the rail off. Carefull not to make it too loose. Your barrel then will be loose and accuracy is out the window. The pin needs to compress when installing or removing the barrel.

[Buckwheat]

I had this same problem. I was using a LX bolt and an MS Pro barrel. The barrel was offset just a bit in the muzzle of the marker. The bolt would stick into the back end of the barrel adaptor. I took a wooden dowl and tapped on the end of the bolt to pop it back into the gun. I had to quit using the MS pro and stick to using my J&J ceramic. Never had any more problems.

[flyingpootang]

alright so i was playing with my mag and all the sudden the bolt started stopping at the position where it hit the ball. so i was investigating this problem and then i try to take my barrel out and what do u know i cant take it out i twist it out of its normal position and try to take it out but it wont go to far in either direction it wont come out and it wont go back to its normal position. any help it would be hugely appreciated!!!!!!!!!!!!!!!!!!!!!!!!!!!
mike19087

I just had the same problem. The reason mine wouldn't come out was because the screw that held the trigger to the body was to long. You can verify this by looking at the end of the twistlock for sign of scratches or depressions. If you remove the valve screw and the trigger frame screw both halves will seperate. Also check your barrel lock detent to see if its rusted/frozzen