I have an old 9 volt VL 2000 loader. I've already hooked up the switch inside the Intelliframe trigger frame. But when I openned up the hopper, what I have is different than what's in the instructions.
In the instructions, it has the board, the motor, and the eye sensor. From the board, it has 4 wires going into the motor, and from the eye, it has 2.
On mine, I have 2 wires from the 9v(boardless), and 4 wires from the eye. I can't figure out how to hook up the 2 wires that come from the male connection of the extension cord.
So if I can roughly describe my set up:
9v(connects to motor with RED and BLACK wires) -> Drive motor <- Eye Sensor(connects to motor with RED, BLACK, BLUE, and WHITE wires).
Where do I go from here? Any and all help would be appreciated!
In the instructions, it has the board, the motor, and the eye sensor. From the board, it has 4 wires going into the motor, and from the eye, it has 2.
On mine, I have 2 wires from the 9v(boardless), and 4 wires from the eye. I can't figure out how to hook up the 2 wires that come from the male connection of the extension cord.
So if I can roughly describe my set up:
9v(connects to motor with RED and BLACK wires) -> Drive motor <- Eye Sensor(connects to motor with RED, BLACK, BLUE, and WHITE wires).
Where do I go from here? Any and all help would be appreciated!