I hooked my new nitrogen up to my mag today, I chrono'ed in, & it jumped around alot. It was jumping from 290 to 275 + or - 10fps. I was wondering what I could do w/ it.
-
-
well did u have nitro on before u got ur new tank or did u have c02? -
If its a classic air valve just replace the reg seat and you should be fine.Comment
-
well the last time i played i had co2 on it, but the reg seat looks fine. i dont see any nicks or anythihng on it, just the imprint where it staus on the valve/charger.Comment
-
is there any other suggestions??Comment
-
I wouldn't say the 8 hole mod is helping the problem. Replace the reg seat. +/- 10 isn't that bad however my classic valve gets around +/- 4
Taking mags apart is fun, its even more fun when you don't know what you're doingComment
-
Everytime you unscrew the two halves and look at the reg seat it needs to be replaced because it will never reseal the same way again
Comment
-
This should be in Tech. And so it shall be...Comment
-
What are you talking about??? Thats not true...Originally posted by xmetal2001
Everytime you unscrew the two halves and look at the reg seat it needs to be replaced because it will never reseal the same way againComment
-
Paintballer86, it IS true. Go look at Rob's post above on reg seats. The regulator pin base makes a circular impression on the reg seat. Everytime the two halves of the valve are seperated and reassembled the impression will not be in the exact same spot as the original impression, causing something similar to an AUDI symbol. This in turn, creates erratic velocities.
Taking mags apart is fun, its even more fun when you don't know what you're doingComment
Comment