Emag E-mode crazy bounce....

[Dark Frost17]

hey
I have a emag with the correct on/off cross fire 70/45 stubby hp, and x valve.
i have the 1.37 software.. now i was dry firing and notice it is a bit on the bouncy side if the trigger isent pulled fast or far enough... .... i only have one magnet (thats all it came with) and i put a few sheets of paper to lighten the trigger pull..... and Bam it was screaming.. .. ...thats not fun or cool.....
so any suggestions? tips?... i am playing tomorrow

Darkness

[Cow hunter]

deal with the bounce?

[Dark Frost17]

>?????

i shot a buddys emag once and his had pretty much none.......there was a tunablade on it would that help or should i add more magnets?

[Tunaman]

make sure the trigger rod is in spec. If it is too close to the back of the trigger you may get mad bounce.

[Dark Frost17]

ok

make sure the trigger rod is in spec. If it is too close to the back of the trigger you may get mad bounce.

What is the spec....what should the lenth be of both rods?? ...i dont know the lenth the come from from adg....so who knows the spec.?

[Tunaman]

plunger-3.005
trigger rod-2.125

[psychowarden]

Also, if your looking into getting a new trigger, I would definatly reccomend the Tunablade. Very sleek and has a great feel.