Level 10 bolt w/ Level 7 Tip

[3pac]

Just as the title says, I'm missing my level 10 powertube tip but I need to use my mag on saturday and there's no possible way that the part will get here in time. Could I use the level 7 tip with the level 10 bolt for 1 day but get the part afterwards and make everything okay? Thanks in advance for the help

[Ace12GA]

If you have a level 7 tip, you probably have the bolt; probably easier to convert it back to the level 7 for the weekend. I am pretty sure you can't mix and match the tips like that. Atleast not without damaging it. However, I have not tried this, so I can't say for 100% sure I am correct.

[buzzboy]

I'm pretty sure they are different sizes so it wouldn't work. L7 really isn't that bad, if you have a good hopper anyways.

[3pac]

I gave it a test run a little bit ago, and it worked just like the level 10, just a little more venting. One ball shot through as if it were a chop but it was without a barrel and the twist and lock pin was still up so the ball might have been split by that but it looked like a clean cut in two. If I really have to go with the level 7, I can always adjust my Emag to deal with the slower rates of fire <3 my software (its some ghetto 4.00 stuff). Thanks for the help guys, if anyone else has anything to say just post it.

[paintman1142]

where are you located?

[3pac]

virginia, northern virginia to be exact.

[paintman1142]

never mind then, if you were within a state from Mass. tehn i would drive there tomorow, but thats a bit to far, sorry

[3pac]

Ah okay, thanks for the help.