Screw size and small problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • flyboy
    Registered User
    • Apr 2006
    • 191
    #1

    Screw size and small problem

    I just bought a used Emag. The manual says is an RT ULE for waht its worth.

    Does anyone know the sze of the front triger frame screw? It's either got the wrong on in it or something is stripped since it wont tighten.

    Also the rear trigger thumb screw is finger tight as suggested by the previous owner. When I air the gun up it starts firing in full auto mode even the the emag turned off. Any suggestions of whats wrong?
    Tags: None
    • Dark Frost17
      Darkness...
      • Mar 2006
      • 752
      #2
      10-32 threads i belive i dont rember the lenth...
      some 1 tell me if i am wrong...

        Comment

        • flyboy
          Registered User
          • Apr 2006
          • 191
          #3
          The one I have is 13/16 and seems too short.

            Comment

            • flyingpootang
              Magtechian with X disease

              • Dec 2005
              • 2276
              #4
              Originally posted by flyboy
              The one I have is 13/16 and seems too short.
              Hmmm. On my X and ULE RT it's 10/32. Best thing to do is find the correct diameter and hold the teeth together. If they mash together then it's the same thread pitch. Or go buy a pitch gauge...

                Comment

                Previous template Next
                Working...