Micromag Question

[RoadDawg]

Ok. My Micromag Retrovalve has terrible velocity jumps. I'm using a AA armageddon and have the velocity set at 700 psi. What is wrong and what can I do to fix it?

Nick

edit: what I mean by what was stated above is that it jumps all over the scale never staying anywhere near consistent. Sometimes it is at field speed then next time I chrono it is 50 over or 50 below. I fire a couple more times and it continues jumping all over.

[virus]

umm.... i think you should reread your post.... it doesn't make sense....

also you need to say what it is doing so the rest of us can figure out what to tell you to fix it

[CRiZO]

try turning your output up to around 800 and see what happens, mag's need about 800 input pressure to run consistent, especially RT's... turning the pressure up more ... 850 or so... will change the reactiveness of your trigger too.