Continuous autofire problem

[borisparadigm]

im not sure if anyone else has had this problem, but the problem is that as soon as i gas up my emag it goes into full auto and wont cease firing. when i bought it, it was a MagSmith Paradigm Pro but i've since upgraded it into a ULE E-mag. I've changed the ULT on/off with an Emag on/off (since the ULT doesnt work well with the Emag lowers), and i've made sure it was oiled everytime. i've checked all the O-rings in the Xvalve itself and they're all good. so if anyone has any ideas or solutions they would be greatly appreciated.
-Boris

[Z-man]

Have you measured your on/off pin and your sear pin length to amke sure that they are in spec according to AGD?

Black VCG's Stickied Tolerances Thread (top of the tech page)

What you are describing sounds like your on/off pin is too short or your sear pin length is incorrect.

[borisparadigm]

cool

thanks i'll try messing with the sear.