ATTN all mag pro's Leaking X vavle.

[Shotcaller509]

I just bought a used Xvalve in almost new shape. I put it on my mag and air'd it up. The valve is leaking horribly from the small bleeder hole on the left side of the first half of the valve (right before the big X). I have had some leaking valves before but never seen one leak from there. I am totally clueless and fustrated. I have oiled the heck out of it but still nothing. Please give me your input. Thank you

[tipp-ed off]

Did you try turning your velocity down?

[Shotcaller509]

Leaking x valve

I tried turning veliocity down on the reg all the way but still nothing. It was turned down so much it was almost comming out of the gun.

Did you try turning your velocity down?

[st6212]

If your talking about the powertube part of the valve.

I suggest the following:

a) Make sure the Regulator Seat O-ring and Seat Holder are present and in good order.
b) Pull the Regulator pin assembly out and check that there is no debris stuck inside the Regulator pin chamber or trapped in the Regulator pin assembly. (ie teflon tape or metal shavings etc)
c) Make sure the Regulator pin assembly is intact. (ie nothing missing)

[Tunaman]

change the reg pin orings.