A classic powerfeed body will fit on an emag rail if the pim is rounded out, but do I need to use an emag sear and on off pin as well even if I am not using an emag valve?
-
-
AM/MM rail use a axle pin that you can just drop in with the sear and Emag/RT rail use use a axle pin that is threaded. I don't think you have to use an rt on/off pin. I'm not sure of that. -
The classic body will fit the emag/rt rail. For a sear you need a rt seat for an rt setup. You need an emag sear for an emag setup. If you use a classic rail, then you need a AM/MM sear.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment