ULT Install Instructions

[Battlewear]

Hey all

Well I recently purchased a X Valve from AGD.. I putting it in the mag today but I want to transfer over my ULT.. The only problem is I cant seem to find the installations Instructions. Granted there are lots of HELP threads, are there any sites with Install Instructions? even AGD doesnt have them on their site

Any help would be very appreciated.

[Sudz]

take out the current on/off and pop in your ULT, as easy as that. May need to do some shim adjusting but nothing major with the tansformation.

to take out the on/off use a flat screw driver or something similar and wedge it out.

[Battlewear]

Yea, I was concerned about the shims.. I had like 7 or 8 in it before..

Now with them all out when I screw it together it seems to have a gap there and moves back and forth (up and down)..

[FinchMan]

what was your last valve? with that many shims i'd think it was a classic valve. You probably won't need that many shims with an X-valve.

[st6212]

The gap between the top half and bottom half of the ULT on/off is supposed to be there.

[Battlewear]

what was your last valve? with that many shims i'd think it was a classic valve. You probably won't need that many shims with an X-valve.

Yea sure was.. Sorry, should of mentioned that at the start. Going from the Classic to the X :) very happy about that :)

[SpitFire1299]

You need to take out the orings inside your valve(in the on/off). There should be 2 orings ontop of eachother in there that need to be removed so the ULT can go in. :)