Odd emag issue when put into electronic mode

[warpfeedmod]

When I move the selector switch to E from M the trigger won't move. It's like it's stuck with the safety on? (mind you the safety is off, I can put the marker in manual mode and it fires fine)

when the power is on and the switch is in manual mode, it works fine as well, it only appears to be when I put it in pure e-mode. The safety seems to catch even though it's off?

[REDRT]

I had one do the same thing. Turned out on that one is was the trigger stop set screw on the mode selector switch that had worked itself out not allowing the trigger to move in E mode. I ended up using light thread locker to keep it from doing this.

[flyingpootang]

I also had the same problem except the selector was on 180 degrees out . Becareful if you take the assy out of the frame the spring and ball are a pain to get back in because their at the bottom of the selector. I had to tap a screw on the top of the frame to get it back together