I am new to mags, bought this one on ebay, first wasn't assembled right, got that fixed. was having problems where the bolt would stick open after shooting fast and leak air down the barrel. so I replaced the bolt spring hoping to help. and now if I just gas up and squeeze the trigger once it leaks down the barrel. any ideas? im lost without any Mag experience.
-
-
Put lots of oil into asa and shot it 30-40 times. -
is it a level 10?
if it has level 10, then the problem could be a o-ring carrier size or shim issue. make sure you put a few drops of oil in the Mag too.
Comment
-
I used alot of oil when it started having problems. and I can't get it to stop leaking Co2 long enough to shoot it. it just pours out the barrel when I screw in the tank now.Comment
-
Well, if it has anything other than the classic bolt, it is not designed to use CO2. You probably broke/froze/cracked something.Originally posted by newmagmanComment
-
You can use CO2 on the level 10 bolt. Make sure that you are not getting liquid CO2 in the gun. Get a good expansion chamber, or a remote, and get a anti-siphon tank. You might have fried one of your o-rings in the power tube which would cause your leak. Start by replacing the o-ring in there and see what happens.Comment
Comment