Dimensions of the Mag dump chamber?

[Pneumagger]

What are the dimensions of the pressure holding portion of the Classic Valve? The pressure would nice to know also.

Is there a pick of a real valve cut in half? That would be pretty helpful.

[RapidTransit]

Do you need dimions or volume?

[RapidTransit]

This is what im getting
Bore = .780 -/+ .001
Depth = .890 -/+ .001

But there is also 2 holes drilled at the bottom which would mean that a volume test is in order.

[Pneumagger]

This is what im getting
Bore = .780 -/+ .001
Depth = .890 -/+ .001

But there is also 2 holes drilled at the bottom which would mean that a volume test is in order.

That's odd, the volume listed in haveblue.org say a 1.1in^3 volume. That's not even close.

thank you for listing a much better measurement. I figure with the new dump chamber, I can lower the operating pressure from 350-400psi to about 100-150psi. Granted the spring doesn't take more than that.