Emag Trigger

[Toll]

Just wondering what the correct pull should be.

When the trigger is pulled all the way back currently, the board does the "magnet is too close so I'm going to spaz out" thing. I've been getting relatively low bps ever since I played with the trigger and I think this is the cause, but I could be wrong

Suggestions?

The screw is currently stripped (the allen key fitting) so I dont know how much I can really play with it or how to get that screw going.

[warpspyder]

Well you could wrap some like styrofoam or something with tape, behind the trigger for now, until you can replace the screw.

Short term=rig something
long term= replace that screw


just my misguided opinion.


Or you could just move the trigger stop so that the pull can't go as far....

otherwise just exhaust all means of moving the screw...

(it's the screw on the trigger magnet right?)