emag HELP!!!

[Spaz100]

can someone please post a good clear pic of thier emag board, i took it apart to repaint in, and when i put it back in i noticed that one of the wires going to the noid had come off. so i soldered it back on at the top. now that i have everything back together the board isnt turning on. i'm asking for the pic to make sure that i soldered the noid wire in the right place, or whether i fried my board.

[Spaz100]

ok nevermind, turns out i forgot that the screw that holds the board in place is also its ground connection.

new problem is that when the solenoid fires it is REALLY weak, like the first couple of shots it will be strong but when i walk it it weakens

[flyingpootang]

Spazz, make shure the ground and positive are snug and the noid wires are well soldered. Cleaning out/polishing the noid housing and plunger is also a great idea. Another thing is to check the plunger rod and trigger rod length to see if they came loose.

You can down load the users manual here is Lornecash page for specs/trouble shooting: http://www.niedtech.com/modules.php?...download&cid=5

[smoothballs825]

Spazz, make shure the ground and positive are snug and the noid wires are well soldered. Cleaning out/polishing the noid housing and plunger is also a great idea. Another thing is to check the plunger rod and trigger rod length to see if they came loose.

You can down load the users manual here is Lornecash page for specs/trouble shooting: http://www.niedtech.com/modules.php?...download&cid=5

i already fixed it, turned out the soldering to the board just wasnt that great, so i did it again. sorry on a friends s/n