Re: Tac-One to E-Mag

[jbg00d-2]

Question,

Will the .712 on/off pin fit in the tac-one X-valve on/off assy?

Also, were does the quad o-ring go? thanks.

Brain.

[Mayzons]

Question,

Will the .712 on/off pin fit in the tac-one X-valve on/off assy?

Also, were does the quad o-ring go? thanks.

Brain.

Yes the .712 on/off pin will fit in the x-valve on/off assy. As far as the quad o-ring goes just look at the exploded pic of the x-valve here on AO, the quad o-ring replaces #22.Hope that helps

[jbg00d-2]

Yes the .712 on/off pin will fit in the x-valve on/off assy. As far as the quad o-ring goes just look at the exploded pic of the x-valve here on AO, the quad o-ring replaces #22.Hope that helps

here is what I bought: http://cgi.ebay.com/ws/eBayISAPI.dll...MEWN%3AIT&rd=1

let me know iwhat you think of this setup. Did I do good or did I get burned? thanks.

Brian.

[Mayzons]

here is what I bought: http://cgi.ebay.com/ws/eBayISAPI.dll...MEWN%3AIT&rd=1

let me know iwhat you think of this setup. Did I do good or did I get burned? thanks.

Brian.

Thats not to bad in my opinion.Would of been nice to get the programmer for the X-Mod though just in case you ever need to update the software.For example changing where the ramping starts.You'll love the X-mod it's the best thing out right now.

[jbg00d-2]

Thats not to bad in my opinion.Would of been nice to get the programmer for the X-Mod though just in case you ever need to update the software.For example changing where the ramping starts.You'll love the X-mod it's the best thing out right now.

Just today, I downloaded the software to do the job. But now, I have a differant problem.
The damned shipping service lost it so I'm not sure that I have one now.

Isn't that wonderful