I just bought 5 new on/off o rings, and my gun goes full auto when i have one of them on, the old o-ring, works fine.. but leaks.. any ideas? I think these new o-rings have too tight of a grip on the on/off pin. I made sure it was very lubrication too, but there must be too much friction.. she just kept screaming at me..
-
-
what kind of on off? Uf it's ULT... take a shim out. If it's RT on off, get a longer pin. -
It's very hard to believe that it's the on/off pin... if i put my old o-ring back in, works amazing, but has a slight leak because of the old o-ring, the older o-ring is not the same as the one i bought from agd, made out of a harder material, and it gently allows the on/off to slide through.Comment
-
oh yea, it's a retro valve AND an x-valve, i tried the oring in both.. same effect.Comment
-
What so you mean by "leaks"? Are you getting steady air flow out the front of the bolt when you hold the trigger in?Originally posted by zyklon69
An oring that is too tight probably won't go full auto. It is more likely to hold onto the pin and slow the cycle rather than allow faster cycling. The orings are genuine AGD on-off orings?Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment