My mag is double firing, every one pull of the trigger 2 balls go flying. Its not the nubbin. THe second ball will go about half way too. Earlier today it was doing it then it stopped and its doing it again. Is it the sear?
-
-
Is the gun actually cycling twice per trigger pull or are just two balls coming out per one pull.
If it is problem one it is probably some kind of bolt or sear wear problem. If it is the second problem then it is the nubbin. -
Its cycling twice per pull. Thats what I was thinking that it was the sear.Comment
-
check it for visable wear and if you see it on either the sear or bolt you need a new one. I believe AGD covers this in warranty. Good Luck!!!Comment
-
does this look worn to you? sorrw about the shadow, couuldnt find the dig cam.Comment
-
.
.Comment
-
for some reason it looks a little short.. the rod should measure 1.98 from the tip of the rod to the pivot spot.. im pretty sureAO #765
CCM Series 5
Prerelease Impulse
Hyperframed Warped Mag w/flatline tank
Feedback.
Good to know that somone of Tom's status seeks "relief" from a sport he helped create. A sport now ruled by a single patent.Comment
-
It was messed with when i got it. One guy compared his and said it was right a while back. It has always worked fine, up until today.Last edited by p8ntballa; 02-02-2002, 04:36 PM.Comment
-
Mine looks nice and brass finished still. Your does look a bit shawdy. I would replace it if I were you.Comment
-
ur sear looks weird.Someone took away my cool sig. *cough*mod*cough*Comment
-
I fixed it and it wasnt the sear. The scanner does funny things to stuff you scan it still has the brass finish except where the pin catches, the on off pin, and aroudn the sear pin.Comment
-
the sear doesn't look too bad, perhaps it's the trigger rod.. it looks like it doens't have any thread stuff on it (loc-tite), and it may have come undone/out of position.***************************************
To do is to be. -Descartes
To be is to do. -Voltaire
Do be do be do. -Frank SinatraComment
Comment