I just ordered the plastic diverter plate but it still jams and wont push the balls. I have intellifeed and i can see the warp motor spinning. Sometimes there wont be paint in it and it wont spin right. Any help would be good. Thanks!!!
-
www.teamrhythm.net
Rhythm milled freeflow cocker with E-blade...it's so nice having your own gun!!!
Sponsors:
www.sirepaintball.com
www.4freeflow.com
Planet Eclipse
Detroit Thunder/Draxxus -
Is the drive belt slipping on the brass wheel? Ive seen this happen, and if the warp is real old the belt may be worn out a little bit.AO #765
CCM Series 5
Prerelease Impulse
Hyperframed Warped Mag w/flatline tank
Feedback.
Good to know that somone of Tom's status seeks "relief" from a sport he helped create. A sport now ruled by a single patent. -
I just ordered a couple of the pulley o-rings. That should help. I think??www.teamrhythm.net
Rhythm milled freeflow cocker with E-blade...it's so nice having your own gun!!!
Sponsors:
www.sirepaintball.com
www.4freeflow.com
Planet Eclipse
Detroit Thunder/DraxxusComment
Comment