![CoFFeY[NiTrO]](data:image/svg+xml;base64,CgkJCTxzdmcgeG1sbnM9J2h0dHA6Ly93d3cudzMub3JnLzIwMDAvc3ZnJyB2aWV3Qm94PScwIDAgNTAgNTAnPgoJCQkJPHJlY3Qgd2lkdGg9JzEwMCUnIGhlaWdodD0nMTAwJScgZmlsbD0nIzczYjQ3NicgLz4KCQkJCTx0ZXh0IHg9JzUwJScgeT0nNTAlJyBmaWxsPSd3aGl0ZScgZm9udC13ZWlnaHQ9J2JvbGQnIGZvbnQtZmFtaWx5PSdBcmlhbCcgZm9udC1zaXplPSczMDAlJyBkb21pbmFudC1iYXNlbGluZT0nY2VudHJhbCcgdGV4dC1hbmNob3I9J21pZGRsZSc+QzwvdGV4dD4KCQkJPC9zdmc+CgkJ "CoFFeY[NiTrO]")
OK I think I found out why my hyperframe wont work.
I have an old body rail on my mag.
Did the old body rail make the sear sit back further than that of ones produced in 1997 + ?
Because on my mag the sear sits further back than the hole where it supposed to go into for the sear to touch the solenoid, thus making bad contact (or no contact at all).
I have an old body rail on my mag.
Did the old body rail make the sear sit back further than that of ones produced in 1997 + ?
Because on my mag the sear sits further back than the hole where it supposed to go into for the sear to touch the solenoid, thus making bad contact (or no contact at all).
![[NA]WARLORD](data:image/svg+xml;base64,CgkJCTxzdmcgeG1sbnM9J2h0dHA6Ly93d3cudzMub3JnLzIwMDAvc3ZnJyB2aWV3Qm94PScwIDAgNTAgNTAnPgoJCQkJPHJlY3Qgd2lkdGg9JzEwMCUnIGhlaWdodD0nMTAwJScgZmlsbD0nIzk0NjI1NCcgLz4KCQkJCTx0ZXh0IHg9JzUwJScgeT0nNTAlJyBmaWxsPSd3aGl0ZScgZm9udC13ZWlnaHQ9J2JvbGQnIGZvbnQtZmFtaWx5PSdBcmlhbCcgZm9udC1zaXplPSczMDAlJyBkb21pbmFudC1iYXNlbGluZT0nY2VudHJhbCcgdGV4dC1hbmNob3I9J21pZGRsZSc+WzwvdGV4dD4KCQkJPC9zdmc+CgkJ "[NA]WARLORD")
Comment