Assemble your level 10 like shown in the diagram. The carrier and oring combination should fit on the bolt stem with only a slight bit of resistance and should slide without much effort. If it slides on its own when the bolt is held vertical, then it is too loose. If you have to force it, then it is too tight.
1) Place the backing washer in first.
2) Insert the carrier and oring (oring facing in).
3) Screw tip into powertube.
4) Insert bolt
5) Place bolt spring over bolt
6) Insert valve assembly into gun body
There is no top washer.
Try this setup and see if it works. Don't worry about the shims. It'll work fine without them.
1) Place the backing washer in first.
2) Insert the carrier and oring (oring facing in).
3) Screw tip into powertube.
4) Insert bolt
5) Place bolt spring over bolt
6) Insert valve assembly into gun body
There is no top washer.
Try this setup and see if it works. Don't worry about the shims. It'll work fine without them.
Comment