Mounting vertical bottle adapter

[Smoothice]

Hello,

I am awaiting a vertical bottle adapter (thanks MANN).

Before I receive it I am trying to figure out how to actually mount it.

Here is a bottom picture of my gun.

[IMG] [/IMG]

I assume I would just drill a hole in front of the trigger guard. Before I drill I wanted to make sure.

So, How do you mount a vertical bottle adapter onto the gun pictured above?

Please be specific.

Thanks.

[ghostdog2019]

Drill and Dremel

You will have to dremel out a chunk of the frame so that the screw does not intrude on the body. Then drill a hole and attach the vertical bottle adapter. Hope that helps

-Mike Brothman

[surfbum]

it would be much easier if you had a mill

you need to drill a hole in front of the grip frame and then countersink the top so the screw sits flush with the top of the rail and doesnt hit the body

[BlackHalo]

Hole might already be there

Take the body of the rail and have a look at the other side. There might be a hole already in the rail with only a little bit left to punch out.

[Smoothice]

Take the body of the rail and have a look at the other side. There might be a hole already in the rail with only a little bit left to punch out.

You are a genius
Well that will make this project much easier.

Thanks

[BlackHalo]

Heh

Glad that helped.

You are a genius
Well that will make this project much easier.

Thanks