two questions on an rt pro

[eric_503]

just one in today that has an emag valve in it and was wondering since i know the valves cant run off co2 for long that if i ran a remoteline off a tank for say half a pod (not even) of paint to make sure it works is that do able is it basicly on the first 3 or 4 pulls im gonna get the liquid and problems?

mind you i dont plan on going fast with it just a paintball or two at a time since i cant find a feedneck anywhere

also how high did the emag valves go? i was thinking in the 10 000 range but ive got valve #561

[athomas]

Its the charge rate of the valve that gets you in trouble with CO2, not the rate of fire. Some people have used CO2 in their retro valves without catastrophe. You take your chances though. If you had a regulator to feed it through, you could reduce the charge rate and it would probably work better. The worst that is going to happen, is you will ruin an oring or two. I doubt it though. It'll probably just leak if the orings freeze.

[2BAD4U]

Yep

It'll leak if the orings freeze .

[eric_503]

update on this :)

yeah i finally got around to trying it

i ran the mag off a remote coil with co2 and it seemed to work fine it only got abit cooler

i ran about half a pod threw it and had todo the finger test and tounge test on the lvl 10 good thing it actually works like it should:)

had some short stroking problems it seemed weird after using the 2 new cockers i got