well i just got my rt valve fixed and now it goes full auto.. like it bounces off my finger when i shoot it what could be causing it to do that
-
68 classic black x-valve /lvl X, black intelli, black pyscho ballistics large drop, 12" smart parts progressive, J&J barrel kit,black evo 2 hopper, carbon 92/4500 crossfire tank :shooting: -
the fact that its an rt valve?
but seriously, how full auto is it going, like 5, 10, 15 bps? or like insance 25? if its the extreamly fast 25 bps like FA, check to see that the on/off has both of the orings on it (one nests inside the other), if its just like 10-15 check your imput psi you might have it up higher that you want (900-1000is when you will start getting noticible FA/bounce)
hope this helps some
-matt -
it was an outrageous full auto but i fixed it i changed out the on/off and lowered my pressure on my tank down to 700
i didn't realize my input pressure was at 1200 (woops) 68 classic black x-valve /lvl X, black intelli, black pyscho ballistics large drop, 12" smart parts progressive, J&J barrel kit,black evo 2 hopper, carbon 92/4500 crossfire tank :shooting:Comment
-
LOL. 1200 psi will definately give you full auto.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
only the slightest bit [/sarcasm]
my friend has his ult'ed xvavle set at 1000 and its can bounce rather fast (12-14 range about)
-mattComment
-
AutoMag RT newbie
Originally posted by SR_mattComment
-
trade you a full funtioning air valve for it no bounce
jk gl on this 
Comment
-
No thank you. I posted here because I was looking for technical advice on how to fix my problem. Not to trade my RT valve for some other indeterminate valve.Originally posted by Sumthinwickedtrade you a full funtioning air valve for it no bounce jk gl on this Comment
-
do you have an adjustable tank? if so take it down to 800ish, if not and its still really bouncy, check the on off. with a stock rt onoff in my mag i will get bounce that goes like 2 -3 bps,
it could have a ult in it that hs a lot of shims in it
-mattComment
-
If you have a preset tank, your not going to be able to adjust the input pressure. Adding a regulator will add additional restriction to the air flow.
If you are getting full auto on an older gun, check the sear tip. It may be slightly worn causing the bolt to not fully catch.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment