Emag/Tach-warp problem..

[Lupis Fidelis]

Hey all,

I just installed my new Tach-warp on my Emag lowers. I ordered the optional rail that AGD bundles with the new body. Everything is great except the rail does not extend all the way out to the end of the battery pack.

The top of the battery pack is a bit exposed and you can see somewhat into the wiring.

Anyone have any suggestions as to how I can go about covering this?

I'm thinking it's not much of a big deal and some electrical or duct tape will do the job...



Any thoughts?

[Thanna]

Hey all,

I just installed my new Tach-warp on my Emag lowers. I ordered the optional rail that AGD bundles with the new body. Everything is great except the rail does not extend all the way out to the end of the battery pack.

The top of the battery pack is a bit exposed and you can see somewhat into the wiring.

Anyone have any suggestions as to how I can go about covering this?

I'm thinking it's not much of a big deal and some electrical or duct tape will do the job...



Any thoughts?

Your best bet would be to get one of RPG rail; the recon or shadow rail will do well. And if you have the warp tac body, you need to get RogueFactor to notch it for you.