X valve trouble.

[Hotaru]

Hey guys,

I have been having trouble with my marker lately and dont know exactly what it could be.

Ok. I have an xvalve and i am unsure if it is a level 10 bolt or not but when i go to pull the trigger sometimes all i get is a "Pshhh" And no paint comes out. I have another mag that does this only when there isnt enough air in the tank.

What can i do to fix it.

The X valve doesnt have any stars on it so does that mean i can send it all in and get it looked over?

I am thinking about sending it in anyway. Where do i send it to and what all should i include in the package?

thanks.

[nathanjones008]

hey

do you have enough air in the tank? when it makes that pss sound does it still shoot?

[Hotaru]

yes it still does it with a full tank.

[longi]

Is your velocity turned up? For the level 10 to do that, i would say it's the velocity.

[FA22RaptorF22]

if air is coming down the barrel check the powertube shims. go to the smallest and work up from there.

[Hotaru]

If i send it to AGD would they fix that? Or do i have to fix it on myown. I'm not too worried about fixing it but if i can have a pro do it i'd rather that.

[nathanjones008]

fix it save$$$

just read some forums, it could be your level 10 , you might have to invest in some time, a few hours, i similar problem with my level ten, so i went up a carrier on my level ten and it stop. i wouldnt take it in , it may cost you tons and tons of money.

[Hotaru]

i'll keep reading forums and stuff, But any one else have an idea and what can i do to remedy it? i mean its not that big a problem but i cant shoot the gun very fast. maybe its just my velocity, I'll try to get her up and running again tomorrow after work.

[flyingpootang]

Make shure your using a High pressure output tank, use the shortest spring it came with, make shure your velocity is up, use the loosest carrier that will not leak, and start with 2 L10 shims. All of these items should get your marker firing. Then you can fine tune it. one

[Hotaru]

Thanks alot man. I dont have any spare shims where would i get them if i need em?

[BSSJackal]

well with a lvl 10 bolt that sound is the sound it makes instead chopping a ball. x valves come with a lvl 10 bolt. are you using a gravity feeder? if your hopper doesnt feed fast enough youll get that . chances are good that the sound you are hearing is the lvl 10 bolt working just the way it should.

[flyingpootang]

To tell if you have a L10 bolt remove the bolt and look at the base. If it has a hollow steam that sticks outof the bottom it's a L10. Either Email Tuna at [email protected] for shims or get them from AGD online store.