Intelliframe Help-Dimensions

[Papa_Smurf]

Could someone provide Dimensions of on intelliframe?
most important is the area where the sear comes down into the frame, width/length/height inside, and all Dimensions of the switch mount.

Thanks in advance for you assistance!

-Ben

[flyingpootang]

Ben, If your trying to convert a standard frame to an intelli, you can use a mounting bracket that is bendable molded in a upside down U, a roller lever switch from Radio Shack, a tie wrap, and some epoxy. The roller has to engage when the sear leg is near the end of the fire stroke. The switch is can be adjusted by moving the switch forward or aft of the bottom of the U. The U bracket can be adjusted by moving it up or down in the frame. You can then epoxy the bracket in place to prevent movement.

[Papa_Smurf]

I thank you for your advice, but I am not looking to do that..
I just need the demensions..