Ton of Questions about my New Emag

[Aramil]

Heres the list:

1. Will a Level 10 w/o the foam thing in the front, presumably the part that hits the paintball, still work?

2. Will an X-Valve work in an E-Mag assuming I took the ULT out and replaced it with the one from the E-Mag valve?

3. Does anyone know where to get a replacement spring and ball detent for the http://store.airgun.com/index.cfm?fu...&categoryID=24
It popped out when I was installing a new trigger and now I cant find the two so it wont lock into place.

4. Will an X-Valve with a ULT work with an Emag? Im assuming not just wanted to check.

Thanks, any help would be appreciated.

[Rudz]

x valve with emag on/off ? --- yes

ult? --- no

i think you need the foamie at the end of the bolt, but i have never tried it.

tunaman has the baering and spring send him an email---[email protected]

[athomas]

The level 10 bolt will work fine without the foamy.

The safety detent spring and ball detent:

http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=171&categoryID=24

http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=178&categoryID=24

[Piranti]

I sent a Foamie with the Marker, just superglue it to the bolt =), unless you accidentally threw away that little bag of parts for the lvl 10. Which had all the carriers and shims.

I also think I have a spare detent in my parts bag, The Xvalve with the Emag on/off assembly will work fine. Used it on that particular emag in fact. Sorry about the foamy lol blew it off that bolt from the xvalve and just switched bolts =P and forcot about it.

the normal Xvalve on/off will not work in the Emag without problems. the little black quad ring and the length of the pin itself is really the only difference.

[Aramil]

Thanks everyone. Ya Piranti I posted this before I actually found that small bag of parts.

[Piranti]

lol ok good, jsut making sure you didn't accidentally throw that small bag wrapped in bubble wrap away.... that would have been bad =P