Emag/Warp Feed Molex Connector
I was wondering what the EXACT Molex connector used on the emag/warp feed intelli cable was.
I am using this for a reference to locate another plug simular in size but pin spacing and mount/locking differences.
In case anyone wants to know the exact connector the plug would be fitting into - - - the Solenoid connector on the System X Xonic Autococker board.
Why?
I have purchased this board and am using it to do an electronic trigger conversion on a Z-Grip I have.
The board is in place. The solenoid needs a plug and it can be mounted. Soon as I get the right plug, I can put some air through it and see if it fires as fast as the little lights blink.
(For those wondering how fast the lights blink,.... think above 16Bps. According to the software thats how fast its power cycling)
I am using this for a reference to locate another plug simular in size but pin spacing and mount/locking differences.
In case anyone wants to know the exact connector the plug would be fitting into - - - the Solenoid connector on the System X Xonic Autococker board.
Why?
I have purchased this board and am using it to do an electronic trigger conversion on a Z-Grip I have.
The board is in place. The solenoid needs a plug and it can be mounted. Soon as I get the right plug, I can put some air through it and see if it fires as fast as the little lights blink.
(For those wondering how fast the lights blink,.... think above 16Bps. According to the software thats how fast its power cycling)
Comment