Spydermag tuning?

[tac one]

I got my Spyder frame for my Tac One automag and I'm able to rapid fire about 10 to 12 bps with the spyder frame, but then the trigger goes limp with no air pressure. If you wait about a second or 2, you can hear air pressure build up and the trigger pops out ready to fire again. It does it all the time. The frame I have is the spyder rocker trigger.

HELP!!

[Pneumagger]

Pictars.

Lube the ULT on off.

[SR_matt]

it coudl also be that the pin is not getting pulled back all the way when it shoots. its so close to shooting its not even funny but it still hasnt triped.

that happened on my friends mech mag and once we adjsuted the trigger on his UMF it worked ok.

-matt

[tac one]

it coudl also be that the pin is not getting pulled back all the way when it shoots. its so close to shooting its not even funny but it still hasnt triped.

that happened on my friends mech mag and once we adjsuted the trigger on his UMF it worked ok.

-matt

How did you adjust it?

[The_Don_83]

[SR_matt]

idk exactly what to tell you since its a spyder mag frame, but if you can make the pin get pushed farther that might help it

-matt

[BigEvil]

Can I assume that its an xvalve we are talking about here? Either way, cram as many shims as you can into the ult. I even shaved the pin on the one I built long long ago.

If you have a mech frame available, make sure the ult and valve are functioning properly with it. Then go from there.

[tac one]

Yes it is an X-valve. I already put enough shims. Anymore, it won't fit in the body. I'm going to try the spring because it is a silver one in it. I'll try see with red or yellow.

Thanks....

Give me more soutions please. You guys rock!

[flyingpootang]

Sounds like the on/off may be a little tight. Remove it and check for free movement and dirt. Oil it well as well as checking to see if the o-ring is not binding.

[baddogsrus]

Adjust the carrier

You might want to try adjusting the carrier (i.e., experiment with larger carriers). The bolt might not completely seat against the bumper and not allow the sear to reset. This happened with my X-valve.

[LinearGoose]

This happens with hyperframes if I recall. Sort of the same except yours is a spyder. I think to fix it all you need to do is change your spings and maybe lube up the ult.

[chettacheez]

Use the gold spring, go up a carrier size, and clean out your valve

[tac one]

Use the gold spring, go up a carrier size, and clean out your valve

What do you mean carrier size?

[SR_matt]

the level 10 carrier that is in side your powerr tube. go up to resources and level ten guide on any page here and it will walk you through some of the tuning, im pretty sure the indepth instalation part will help you understand all of that.

-matt