I recently built a mag that has a twist lock barrel.
I replaced the detents with new out of the package plastic style detents and new orings holding them in place.
My issue is that if I use anything other than a revvy it pushes the balls through the detent and I am double/triple firing.
The Egg3 is the worst, the Halo (force fed) doesn't do it near as bad but still does it(which is confusing).
I don't mind using my trusty old revvy but I wanted to use the Egg3.
I'm in search of a Doc Nickel twistlock to A/C thread adapter but haven't had any luck finding one.
Is there anything else I can do to strengthen the detents? Any old skool tips and tricks until Doc has the adapters available again?
I replaced the detents with new out of the package plastic style detents and new orings holding them in place.
My issue is that if I use anything other than a revvy it pushes the balls through the detent and I am double/triple firing.
The Egg3 is the worst, the Halo (force fed) doesn't do it near as bad but still does it(which is confusing).
I don't mind using my trusty old revvy but I wanted to use the Egg3.
I'm in search of a Doc Nickel twistlock to A/C thread adapter but haven't had any luck finding one.
Is there anything else I can do to strengthen the detents? Any old skool tips and tricks until Doc has the adapters available again?
