I just picked up a Emag this week. I aired it up last night and shot it a few times. Mech mode shot fine, E-mode was a little stiff maybe a little trigger adj. will fix it up. I shot a hopper full of paint through it and towards the end it sounded like it was sticking or something. I picked up a scuba tank today to do some adj. on the gun. I air it up sounds like the valve aired up properly, but it will not shoot. I took everything apart and I think the problem might be in the on/off assy. If I understand right the Emag should have a different on/off and a .712 pin. The on/off assy. is just like the one in my original RT. It does not have the quad O-ring, so I am thinking it probably is not the right pin either. Would this cause the gun not to shoot? What happens if you have the wrong on/off assy. in?
-
Last edited by Elevatn; 01-18-2007, 11:05 PM. -
I had similar issues on my X-valve: wrong on/off o-rings in the valve side. My 'mag still fired, but the bolt stuck a lot and refused to reset after every three or four shots. Once I got the o-rings changed (thanks Joe, from Velocity Paintball) and switched to the right carrier it worked just fine.
You might be able to make it work as is, but I had much better results from using the correct parts. -
I will give that a try, thanks.Originally posted by echobackComment
Comment