minimag help
Okay guys I have a little problem with my minimag I just purchased off of here. It leaks air, it's coming from the front of the gun where the barrel attaches. I don't know anything about minimag's except for the fact that I have wanted one since I started playing paintball over 3 years ago. I used co2 to test fire the gun. I know, I know, this is a big no no with mags in general, but my nitro tank is in the mail and coming soon. So I just emptied my co2 tank in the mag. But back to the problem at hand, the minimag is right feed and has dye grips and a dye regulator front grip. I was planning on taking out the rear valve and replacing the o-rings but couldn't figure out how to do that either. So a diagram on what to take out and lube would be great in that regard as well. It's not leaking a tremendous amount of air and it's not even noticeable if you don't know what to look for. But I guess I just want to know what to do to fix this. Thanks any techies in advance for your help.
-
-
You should buy a parts kit.http://store.airgun.com/index.cfm?fu...&categoryID=18
If its not a level 10 bolt, replacing the powertube oring may stop the leak.
Heres an exploded view
HR minimag
Benchmark rail(red)
Drop zone 2(red)
Blade INTELLIFRAME
WARP feed(clear)/12v Rev
114 crossfire hps
10" dye ss barrel -
thanks
I will do that and thanks for the exploded view of the valve, that helps a lot also. I will get the parts kit and see if that helps and if not then I will be posting something else about how I messed up my gun. Thanks thoughComment
Comment