Length Of SS hose and Quick Disconnect?

[Sammy Sandbag]

I just got my MiniTac and it currently has the SS hose run directly from the valve to the bottom ASA in a 180* bend. I'd like to run it from the valve to the vertical ASA/bike grip, then from there to the on/off ASA on the bottom of the 45 grip.

I took some measurements and it looks like about 5.5" from the valve to top of the foregrip fitting, then 4.25" from the bottowm of the foregrip fitting to the ASA fitting.

So the question is: what length is a standard quick disconnect? I would need to factor this length in, as it would require a shorter hose. Also, are hose lengths normally a measurment from the end tip of the threads, or do they measure them in another fashion?

Anyone with a similar setup that could provide the lengths they used would be much appreciated.

Thanks in advance,
Sammy

[Tunaman]

You cant get a QD on the valve side...even with the modified tac Body. There just isn't enough clearance.

[Sammy Sandbag]

You cant get a QD on the valve side...even with the modified tac Body. There just isn't enough clearance.

Right, I understand that. I was planning on putting the QD at the foregrip 90*

[Tunaman]

OK then. The QD with the male end installed is 1.5 inches.

[Sammy Sandbag]

OK then. The QD with the male end installed is 1.5 inches.

Cool, thanks!