E-Mag problem and X-Valve problem (need help on a couple of my mags) -

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • 99GenX
    Professional Gun Whore
    • Apr 2005
    • 419
    #1

    E-Mag problem and X-Valve problem (need help on a couple of my mags) -

    Tags: None
    • athomas
      Of course it works-its AGD
      • Jan 2002
      • 8039
      #2
      The Halo should be able to keep up to any mechanical gun. Try a new bolt spring. If it is worn or weak, it could slow down the cycle speed of the bolt.

      On the emag, you can hear the solenoid click so it is getting its trigger actuations. Since it fires in manual mode, the valve sounds like it is fine. Check the solenoid plunger adjustment. If it is out of adjustment (too short), it could be too weak to pull the sear.
      Except for the Automag in front, its usually the man behind the equipment that counts.

        Comment

        • MANN
          I am in TN. GO VOLS.
          • Apr 2006
          • 4266
          #3
          search for the correct length micro Emag pin. IIRC my micro E uses an on/off pin that is less than .712 Either way you should probally invest in a good set of calipers to measure your on/off pin, and sear adjustments. I think mine was~.690, but I will have to go remeasure to know for sure

          what on/off oring are you using. The quad one works best. Make sure that it is oiled good. Also check your dwell, etc adjustments with the xmod manual. If you dont have one download one or pm me, and Ill foward you the link.

            Comment

            Previous template Next
            Working...